XADO Diesel Engine Power Restore Revitalizant has been designed for wear protection and restoring repair of gasoline and diesel engines without disassembling.
XADO latest In-Place Nano Technology will bring you car or diesel truck performance back to nominal with 3 simple and totally DIY diesel engine revitalizant treatments.
During the engine operation, the cylinder- piston group in the upper "dead" point, parts of the gas distributing mechanism (campusher), friction bearing of the crankshaft and button shaft are subject to major wear. XADO Diesel engine power restore revitalizant contains the construction material which compensates the wear of these parts. As a result of revitalization, a new multifunctional gradient coating is formed on the surfaces of friction pairs with a set of the required service characteristics and stress states. Engine parts grow in volume and return "hundreds" and "tenths" which have been lost while engine operating. This is the repair effect by top quality XADO engine treatment gel.
The obtained by XADO revitalizant coating possesses unique properties: significant durability, high rustproof quality and low roughness. After revitalization, the engine parts are guaranteed to serve 2-4 times longer. This is the effect of XADO diesel engine wear protection.
How to use XADO Diesel Engine Power Restore Revitalizant:
For an diesel engine with oil capacity of 3-10 liters.
Stage 1: Squeeze out the contents of one XADO Diesel Revitalizant tube into the oil filler neck of the engine warmed up to the working temperature. Start the engine and let it idle for 5-10 min.
Stage 2: Repeat the procedure after 100-250 km run.
Stage 3: Repeat the procedure after 100-250 km run after completing Stage 2.
Fast, specific and genuine results, which can be easily tested and measured, as well as the simplicity of application - is the reason to choose XADO technology.
Important Note:
- Oil must not be changed until the end of the treatment.
- Treatment is considered to be finished after the mileage of not less than 1,500 km.
- Treatment can be done at idling (4 hours is an equivalent of 200 km run).
- New engines with run about 20,000 km should be treated in one stage.
- Engines after overhaul are recommended to treat in a usual way in three stages.
- Treatment of engines working on liquefied gas is similar to the treatment process of gasoline engines.
- Protective metallceramics coating is formed on any working mechanism, however, if the mechanism (engine) is in a critical condition (100% wear), the destroyed parts should be replaced.
DEPENDS ON YOUR LOCATION THIS PRODUCT CAN BE SHIPPED FROM USA OR EUROPE
ADDITIONAL DISCOUNTS AVAILABLE WHEN BUY QUANTITIES OR COMPLETE CAR TREATMENT PACKAGES. Contact us for details